Breadcrubs

DURA CRIB® WEDGES


As almost every cribbing situation involves uneven surfaces, use wedges to stabilise crib stacks when necessary. Wedges are used to fill the gap between the stacked cribbing and the structure, product or vehicle being secured. Wedges should be similar width as the cribbing block or stack. By using wedges almost any gap can quickly be filled to create a safer working environment.

  • Hi-visibility yellow or ultra-strength black
  • Tested under the guidance of AS1170.0.2002 and AS2498.3.1998
  • 100% recycled high density polyethylene (HDPE) construction for durability
  • Lightweight
  • Resistant to fuels, oils and most common chemicals
  • Will not splinter or rot
  • Non-conductive
  • Operating Temperature range -40°C to +75°C
  • 50 year warranty against splitting, rotting, absorption, termites and mould



* Total Block Working Load Limit (WLL) is based on a full press load evenly distributed across the top and bottom surfaces of the cribbing block.

Warning: Always perform your own risk assessment before using this product. Always know the weight of the equipment or machine being supported. Consult your equipment and machinery manufacturer manual and guidelines for recommended blocking and lifting points. Never exceed the maximum WLL of the cribbing blocks or cribs. Under no circumstances does the WLL mentioned above take into consideration point loading or uneven weight distribution of the supported load. Copies of Technical Data Sheets and the Technical Operating Manual for Composite Cribbing can be obtained from the resource page of this web site, emailing info@cribandmatco.com.au or calling 02 9674 7428.